This page is part of archived documentation for openHAB 3.3. Go to the current stable version

# Helios Binding

This binding integrates the Heliop door/videophone system (https://www.2n.cz (opens new window)).

# Supported Things

Currently, the Helios IP Vario is supported by this binding, running the 2.21 version of the firmware

# Binding Configuration

There is no specific binding configuration

# Thing Configuration

The ipvario221 Thing requires the IP address of the videophone, and the username and password as a configuration value in order for the binding to log into the videophone.

In the thing file, this looks e.g. like

Thing helios:ipvario213:gate [ipAddress="192.168.0.14", username="admin", password="mypassword"]

# Channels

All devices support the following channels:

Channel Type ID Item Type Description
keypressed Trigger Code of a key pressed on the videophone keyboard
keyreleased Trigger Code of a key released on the videophone keyboard
callstate String State of the call being made
calldirection String Direction (e.g. inbound, outbound) of the call being made
card Trigger ID of the card presented to the RFID reader
cardvalid Switch The card presented to the RFID reader is valid (i.e. registered in the Vario)
code Trigger Numerical PIN code (i.e. 1234) entered on the keyboard
codevalid Switch The code entered is valid (i.e. registerd in the Vario)
devicestate String State of the device

In addition, devices running the v2.13 firmware support the following channels as well:

Channel Type ID Item Type Description
audiolooptest Switch Initiate an audio loop test
motion Switch Indicates if motion was detected by the videophone
noise Switch Indicates if noise was detected by the videophone
switchstate Switch Indicates the state of an internal switch in the videophone

For most of the channels a "stamp" channel (of Type DateTime) (e.g. "keypressedstamp") is available and will be updated with the time stamp the relevant event happened on the device. For switchstate, there are as well the switchstateswitch and switchstateoriginator channels indicating the number of the switch that changed state (1 to 4, depending on the hardware configuration) and the source of the switch state change (keypad, DTMF signal,...)

# Full Example

demo.Things:

Thing helios:ipvario221:gate [ipAddress="192.168.0.14", username="admin", password="mypassword"]

demo.items:

String GateKeyStamp "[%s]" (helios) {channel="helios:ipvario221:gate:keypressedstamp"}
String GateCardSwiped "[%s]" (helios) {channel="helios:ipvario221:gate:card"}
String GateCardStamp "[%s]" (helios) {channel="helios:ipvario221:gate:cardstamp"}
String GateCardValid "[%s]" (helios) {channel="helios:ipvario221:gate:cardvalid"}
String GateCodeEntered "[%s]" (helios) {channel="helios:ipvario221:gate:code"}
String GateCodeStamp "[%s]" (helios) {channel="helios:ipvario221:gate:codestamp"}
String GateCodeValid "[%s]" (helios) {channel="helios:ipvario221:gate:codevalid"}

demo.rules:

rule SomeRule
when
    Channel "helios:ipvario221:gate:keypressed" triggered 
then
    var actionName = receivedEvent.getEvent()
    logInfo("org.openhab","Rule trigger " + actionName)
end